Chapter 2 Setup
83
2
Infrastructure settings (Windows Embedded POSReady 2009)
1
Click [Start], then [Control Panel]. Run "Network Connections".
2
The Network Connections window is displayed. Right-click [Wireless
Network Connection], and select [Properties]. The "Wireless Network
Connection" window is displayed.
3
Click on the [Wireless Networks] tab.
4
Click [Add].
The "Wireless Network Connection Properties" window is displayed.
5
Input the SSID and network settings, make sure there is not a check in the
checkbox for "This is a computer-to-computer (ad hoc) network, wireless
access points are not used", and click [OK].
The set infrastructure network is displayed in the "Preferred networks" list.
Ad hoc settings (Windows Embedded POSReady 7)
1
Click [Start], and in [Search programs and files], input "adhoc".
2
Click the listed "Set up a wireless ad-hoc (computer-to-computer)
network".
3
Following "Set Up an Ad Hoc Network", input the items, and check "Save
this network". Then click "Next". Follow the directions in "Set up a wireless
ad hoc network", input the items, and check "Save the network".
To Next Page
Loading...
