128
Printing and Cutting Positions
The values above may vary slightly as a result of paper slack or variations in the paper. Take
this into account when setting the cutting position of the autocutter.
When removing cut paper, the remaining roll paper is pulled at the uncut section and the
pitch of the next print may be reduced. When printing after cutting paper for prints with no
pitch reduction, feed the paper about 1 mm {16/406 inches} before printing.
When leaving paper loaded for an extended period of time, make sure you feed about 30 mm
of paper. This can prevent paper from wrinkling and causing prints to be too light.
Autocutter blade position
Approx. 29
Approx. 15
Manual-cutter position
Center of the print dotline
[units: mm (All the numeric values are typical.)]
Paper feed direction
Printable area
Last line of
a previous receipt
To Next Page
Loading...
Need help?
General