Epson TM-T88VI-iHUB Reference Guide

25
Chapter 1 Product Overview
1
Simple Setup for Wireless LAN
This printer comes with a mode (SimpleAP) that allows printers to connect with a smart device or a computer
without requiring a wireless access point. This allows you to easily setup a wireless LAN for the printer by using
a printer settings tool (Epson TM Utility for iOS/Android or EpsonNet Config) even without a network
environment such as access points.
SimpleAP mode is enabled by default when shipping from the factory. When SimpleAP mode is enabled and
the printer is turned on, the following information is printed automatically.
Although operations are performed in SimpleAP mode during the initial startup, operations switch to standard
mode (infrastructure mode) when changing settings in Epson TM-T88VI Utility for Windows or EpsonNet
Config. After switching, operations continue in standard mode. If you want to make settings in SimpleAP mode
again, initialize the communication settings.
* You can also set as standard mode (Adhoc mode)
SimpleAP Start
SSID
Encryption Type
Passphrase
IP Address
MAC Address
: EPSON_Printer
: WPA-2-PSK
: 12345678
: 192.168.192.168
: xx-xx-xx-xx-xx-xx
Standard mode
(infrastructure
mode)
SimpleAP mode
(default setting)
Changing to standard mode
Ex.) Change IP address,
change SSID
Initialize the communication
settings

Epson TM-T88VI-iHUB Specifications

General

Brand	Epson
Model	TM-T88VI-iHUB
Category	Printer
Language	English