81
Chapter 3 Advanced Usage
3
Resetting the Interface Settings
Follow the steps below to reset the interface settings.
1
Turn off the printer and close the roll paper cover.
2
If the connector cover is attached, remove the cover.
See "Attaching the Connector Cover" on page 46 for details on removing the connector cover.
3
Hold down the status sheet button while turning on the printer.
A message is printed indicating that resetting is being performed, and the printer restarts.
You can return the interface settings to their defaults from the Interface Setup mode. See
"Interface Setup Mode" on page 76 for details on the Interface Setup mode.
Only network settings are returned to their defaults.
Hold down the status sheet button until the initialization execution message is printed.
To Next Page
Loading...
Need help?
General