Rev. A Setup 3-21
TM-U220II Technical Reference Guide
When you replace a TM-U210 with a TM-U220II, you should adjust the Msw 8-5 to OFF.
Note:
Msw 8-5:
When Off is selected, a bit of the "roll paper end sensor" in each status that is transmitted from the printer
is changed every time the roll paper cover is open or closed. When On is selected, a bit of the "roll paper
cover open / close" in each status that is transmitted from the printer is changed every time the roll paper
cover is open or closed. When you replace a TM-U210 with a TM-U220II, you should adjust the Msw 8-
5 to Off.
Msw 8-8:
When Off is selected, a bit of the "automatic recoverable error" in each status that is transmitted from the
printer is changed every time the roll paper cover is open. When On is selected, a bit of the "mechanical
error" in each status that is transmitted from the printer is changed every time the roll paper cover is open.
The setting of Msw 8-5 and 8-8 can be set by “Memory switch setup mode.“ See “Memory Switch Setup
Mode” on page 3-23.
Memory Switch 2
SW Function On Off Default
1 Reserved - Fixed to Off Off
2 Reserved - Fixed to Off
3 Selection of the character code system of
the Simplified Chinese
GB2312 GB18030
4 ~ 8 Reserved - Fixed to Off
Memory Switch 8
SW Function On Off Default
1 ~ 4 Reserved - Fixed to Off Off
5 Selection of the cover open status Cover open Paper end
6 Reserved - Fixed to Off
7Reserved - -
8 Printer cover open during operation Errors that can possibly
recover
Errors that automatically
recover
Customize value
Function Selectable value
Automatic paper
reduction
Reduction of top
margin
No margin reduction (default) Reduced
Reduction of bottom
margin
No margin reduction (default) Reduced
Reduction of line
spacing
No reduction (default) Reduced by 25%
Reduced by 50% Reduced by 75%
Reduction of line
spacing where extra
line feeds are included
No reduction (default) Reduced by 25%
Reduced by 50% Reduced by 75%
Roll paper width specification 57.5 mm 69.5 mm
76 mm (default) --
Command execution when offline Enabled Disabled (default)
Automatic paper cutting when cover is closed Cutting performed No cutting (default)
Buzzer function: Enable/Disable optional
external buzzer
Enabled Disabled (default)