Epson TM-U220II - Page 54

3-22 Setup Rev. A
*1: Enabled for optional external buzzer
Note:
These setting can be set by “Memory switch setup mode.“ See “Memory Switch Setup Mode” on page 3-
23.
See “Adjusting Roll paper width” (page 3-28) also to adjust roll paper width.
Note:
There are two methods, DIP switch and Memory switch, to adjust the serial communication conditions.
DIP SW2 selects which is effective, DIP switch or Memory switch.
To enable the “Serial communication“ setting, you have to adjust the “Serial interface selection“ function
of DIP switch 2 to “Memory switch.“
These settings can be set by “Memory switch setup mode.“ See “Memory Switch Setup Mode” on page 3-
23.
Buzzer function: Buzzer repetitions when an error
occurs
*1
Does not sound Only once
Sounds continuously (default) -
Buzzer function: Sound pattern for automatic
cutting command
*1
Pattern A (default) Pattern B
Pattern C Pattern D
Pattern E -
Buzzer function: Buzzer repetitions for automatic
cutting command
*1
Does not sound Only once (default)
Buzzer function: Sound pattern for specified
pulse generation command 1
*1
Pattern A (default) Pattern B
Pattern C Pattern D
Pattern E -
Buzzer function: Buzzer repetitions for specified
pulse generation command 1
*1
Does not sound Only once (default)
Buzzer function: Sound pattern for specified
pulse generation command 2
*1
Pattern A Pattern B (default)
Pattern C Pattern D
Pattern E -
Buzzer function: Buzzer repetitions for specified
pulse generation command 2
*1
Does not sound Only once (default)
Model name TM-U220II (default) TM-U220
Serial communication
Function Selectable value
baud rate 1200 bps 2400 bps
4800 bps 9600 bps
19200 bps 38400 bps
57600 bps 115200 bps
Parity None Odd
Even --
Handshake DSR/DTR XON/XOFF
Data length 7 bit 8 bit
Customize value
Function Selectable value