Epson TM-U295

REVISION SHEET
Sheet 9 of 10
REV. SHEET CHANGED CONTENTS DATE
· ESC 3 [Description] n/60 inch ® n x approx. 0.423mm (1/60 inch)
(Change)
45
· ESC 3 [Description] 1/6 inch ® 4.23mm (1/6 inch) (Change)
49
· ESC J [Description] n/60 inch ® n 5 approx. 0.423mm (1/60 inch)
(Change)
50
· ESC K [Description] n/60 inch ® n 5 approx. 0.423mm (1/60 inch)
(Change)
51
· [Notes] ESC 2 Set 1/6-inch line spacing. ® Set the initial line
spacing. (Change)
54-2
· [Default] n=48 ® n=0 (Change)
60 · [Notes] Since the status is transmitted when this command is
buffered in the receive buffer, ® Since this command is stored in the
receive buffer and then executed during normal command process,
(Change)
62 · [Notes] Since the status is transmitted when this command is
buffered in the receive buffer, ® Since this command is stored in the
receive buffer and then executed during normal command process,
(Change)
64 · [Notes] Since the status is transmitted when this command is
buffered in the receive buffer, ® Since this command is stored in the
receive buffer and then executed during normal command process,
(Change)
· Bit 0 Not used ® Not available for 2-byte code (Change)
65
· Bit 1 Not used ® No auto cutter (Change)
69 · Bit 1 The contents of the NOTE are corrected and added.
(Addition)
· [Notes] Since the status is transmitted when this command is
buffered in the receive buffer, ® Since this command is stored in the
receive buffer and then executed during normal command process,
(Change)
67
· First Bit 5
Not used 00 0 ® Undefined - - (Change)
E
70
· [Notes] Since the status is transmitted when this command is
buffered in the receive buffer, ® Since this command is stored in the
receive buffer and then executed during normal command process,
(Change)
TITLE
TM-U295/U295P
Specification
(STANDARD)