EasyManuals Logo

Epson WF-4820 Series User Manual

Epson WF-4820 Series
387 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #315 background imageLoading...
Page #315 background image
315
9. If you disabled IEEE 802.3az for your computer's network adapter, enable it.
10. Reconnect the Ethernet cables from the router or access point to your computer and product.
If problems still occur, other devices on the network may be causing them.
Parent topic: Solving Network Problems
Cannot Print Over a Network
If you cannot print over a network, try these solutions:
• Make sure that your product is turned on.
• Make sure you install your product's network software as described in your product documentation.
• Print a network status sheet and verify that the network settings are correct. If the network status is
Disconnected, check any cable connections and turn your product off and then on again.
• Print a network connection report and check the codes and messages on the report to help determine
the cause of the problem.
• If you are using TCP/IP, make sure the product's IP address is set correctly for your network. If your
network does not assign IP addresses using DHCP, set the IP address manually.
• If the IP address assigned to the product is 169.254.XX.XX and the subnet mask is 255.255.0.0, the IP
address may not be assigned correctly. Check the IP address and subnet mask assigned to the
product (Settings > General Settings > Network Settings > Advanced) then restart the wireless
router or reset the network settings for the product.
• Make sure your computer and product are both using the same wireless network.
• If network printing is slow, print a network status sheet and check the signal strength. If it is poor, place
your product closer to your router or access point. Avoid placing your product near a microwave oven,
cordless phone, or large metal object, such as a filing cabinet.
Note for Latin America: If you are using a 5 GHz wireless router, set the router to operate in dual
band (2.4 GHz and 5 GHz) mode. If your router uses a single network name (SSID) for both the
2.4 GHz and 5 GHz band, give each band its own network name (SSID) instead, such as Home
Network 2.4 GHz and Home Network 5 GHz. See your router documentation or contact your internet
service provider for instructions.
• Try restarting your router following the instructions in your router documentation.
Note: If you are reading these instructions online, you will lose your Internet connection when you
restart your router.

Table of Contents

Other manuals for Epson WF-4820 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson WF-4820 Series and is the answer not in the manual?

Epson WF-4820 Series Specifications

General IconGeneral
Print Resolution4800 x 2400 dpi
ConnectivityUSB, Ethernet, Wi-Fi, Wi-Fi Direct
Paper Capacity250 sheets
Automatic Document FeederYes
ADF Capacity35 sheets
Duplex PrintingYes
Display4.3" color touchscreen
FunctionsPrint, Copy, Scan, Fax
Scan Resolution1200 x 2400 dpi
Fax Speed33.6 Kbps
Weight20.5 lbs
Print Speed (Black)25 ppm
Print Speed (Color)12 ppm
Scanner TypeFlatbed, ADF
Paper Sizes SupportedA4, A5, A6, B5, Letter, Legal, Executive, 3.5 x 5", 4 x 6", 5 x 7", 8 x 10", 8.5 x 11", 8.5 x 14"
Mobile PrintingApple AirPrint, Mopria, Epson Connect
Ink CartridgesBlack, Cyan, Magenta, Yellow
OS CompatibilityWindows, Mac OS

Related product manuals