eqss Gen-3 LMS - Tools Required for Installation

Tools Required for Installation
The tools required to perform the installation of the TSS are listed below
• Pencil or Texta
• Drill
• Drill bits
◦ 3.3 mm
◦ 4.5 mm
◦ 5 mm
◦ 6.8 mm
◦ 8.5 mm
• Centre punch
• Tap T-Handle
• Taps
◦ M6
◦ M8
• Drill and tap oil
• Metric Allen keys
• Phillips Head screw driver
• Spanners and sockets
◦ 7 mm
◦ 10 mm
◦ 13 mm
• Locktite thread locker
• Side cutters
• Stanely knife
• Crimpers
• Wire strippers
• Torque Wrench
DO001547 VER: 2303241610 5 of 58