eqss Gen-3 LMS - Page 58

To Previous Page

__________________________________________________________________________________

Equipment Safety Systems Pty. Ltd. ABN: 31 061 789 151 Tel: +61 3 8770 6555

75 Naxos Way, Keysborough 3173, Victoria, Australia Fax: +61 3 8770 6590

Web: www.eqss.com.au

DO001547 VER: 2303241610 58 of 58

Main Page

Table of Contents4
Tools Required for Installation5
Installation Index6
Table 1: Component Installation Index6
Table 2: Cable Installation Index7
Illustration 1: Machine Boom8
Illustration 2: Machine Chassis9
Covers10
Table 3: Cover Removal12
Cable Reeler Installation13
Table 4: Cable Reeler Installation15
Cable Reeler Mounting Position16
Illustration 3: Cable Reeler Mounting Position16
Pressure Sensor Installation17
Pressure Manifold17
Table 5: Pressure Manifold Installation17
Compensation Pressure Sensors19
Table 6: Compensation Pressure Sensor Installation19
Can Pressure Input Module (CPIM)21
Table 7: Can Pressure Input Module (CPIM) Installation22
Signal Light Installation23
Table 8: Signal Light Installation25
Forward Camera26
Table 9: Forward Camera Installation26
External Cable Completion28
Table 10: External Cable Completion31
Display Installation32
Table 11: Display Installation32
User Control33
Table 12: User Control Installation33
Can Cabin Interface Module (CCIM)34
Table 13: CCIM Installation34
Machine Connections35
Table 14: Machine Connections37
Cabin Loom38
Table 15: Cabin Loom Installation40
Finalisation42
Table 16: Finalisation44
Set Time & Sensor Calibration45
Table 17: Sensor Calibration47
Schematics48
Appendix A: Attaching Display Connectors52
Table 18: Install Display Connector Procedure53
Illustration 4: Damaged Display Connector54
Illustration 5: Do Not Use Tools to Tighten Connector54
Illustration 6: Do Not over Tighten Nuts55
Appendix B: Reattach Ferrites56
Table 19: Reattach Ferrites Procedure56
Indexes and Tables57

eqss Gen-3 LMS - Page 58

Table of Contents

Related product manuals