Ericsson iPECS LIP-8002E - Page 139

LIP-8012E & LIP-8024E Gigabit Phone User Guide
13
To set default Config. settings:
• In Network Config. Menu, use VOL   buttons to locate the
Default Config. Screen (shown),
SET DEFAULT CONFIG(DOT:*)
•
• Press the * key.
To exit Config. settings:
• Press the SPEAKER button,
• Press the * key to exit,
OR
• Press the # key to Reset/Reboot the phone with new setting.
To configure VPN:
• In Network Config. Menu, use VOL   buttons to locate the
DNS Address menu.
• Enter DNS address in DNS ADDRESS menu
• Use VOL   buttons to locate the VPN configuration screen
(shown),
VPN ?
[ENABLED] – CHANGE[#]
• Enable in VPN Menu and press the Hold button.
• Following steps are available when VPN is enabled.
• Enter VPN Server address in VPN SERVER IP menu and
press the Hold button.
• Enter TCP/UDP port number for both local and remote in VPN
PORT and press the Hold button. The default value is 1194.
• In VPN USER ID, enter ID and press the Hold button.
• In VPN USER PASSWORD, enter Password and press the
Hold button.