Ericsson iPECS LIP-8002E - 8. Set Features & Flex Buttons; 8.1 Entering Station Program Data; 8.2 Assigning Features to Flex Buttons

LIP-8002E/2AE User Guide
28
4.4 Call Park: Placing a call on hold to Page
A user may transfer an active CO/IP call to a special
holding location (Park Orbit), which can be accessed
easily from any station in the system. Typically, this
feature is used with Paging to notify the desired User of
Call Park.
Parked calls are subject to Hold Recall after the Call
Park timer.
In iPECS-LIK, iPECS SBG-1000
To park an active external call:
• Press TRANS/PGM,
• Dial the Call Park Location code,
• Return to idle.
To retrieve a parked call:
• Lift the handset,
• Dial the Call Park Location code.
In iPECS-MG
To park an active external call:
• Press TRANS/PGM,
• Dial the Park Orbit (541),
• Dial the Park number (00~49)
• Return to idle.
To retrieve a parked call:
• Lift the handset,
• Dial the Park Orbit (541),
• Dial the Park number (00~49).