LIP-8012E & LIP-8024E Gigabit Phone User Guide
31
If you are the Attendant or Secretary, you may activate
Intrusion. You may also use Step Call; dial the next
station by dialing the last digit of the Intercom number.
4.1.2 Leaving a Message Wait
If the called user does not answer or is in DND mode,
you may leave a Message Wait. The called user will
receive a Message Wait indication; the message icon
will be displayed in the LIP-8024E. If the ring/message
LED is set to Message Wait Indication, the
ring/message LED will flash.
4.2 External Calls
4.2.1 Placing external CO/VoIP calls
External calls are placed on CO/IP lines. These ‘lines’
are accessed either using a button on the iPECS Phone
assigned as a CO/IP line or using dial codes. The
CO/IP lines are grouped for different types of calls, local,
long distance, etc. Using the CO/IP line group code,
you will be able to access any line from the group. A
Flex button on the iPECS Phone assigned as a
LOOP
button lets you access a line from a group. Dial codes
for access to CO/IP lines are:
Individual CO/IP line access—
88 + Line number (01-10 for iPECS SBG-1000, 01-42
for iPECS-50 & 100, 001-200 for iPECS-300, 001-
400 for iPECS-600, or 001-600 for iPECS-1200).
To Camp-On (wait off-hook) for a busy station:
• Press * and await an answer.
To request a Callback (wait on-hook) for a busy station:
• Press the MSG button and hang-up.
To make a Voice Over announcement to a busy station:
• Dial #,
• After the Splash tone is heard, begin speaking.
To activate Message Waiting:
• Press the MSG button and hang-up.
To Next Page
Loading...
