Ericsson iPECS LIP-8002E - Page 222

LIP-8040E Gigabit Phone User Guide
14
To configure VPN:
 In Network Config. Menu, use VOL   buttons to locate the DNS
Address menu.
 Enter DNS address in DNS ADDRESS menu
 Use VOL   buttons to locate the VPN configuration screen
(shown),
VPN ?
[ENABLED] – CHANGE[#]
 Enable in VPN Menu and press the Hold button.
 Following steps are available when VPN is enabled.
 Enter VPN Server address in VPN SERVER IP menu and press the
Hold button.
 Enter TCP/UDP port number for both local and remote in VPN PORT
and press the Hold button. The default value is 1194.
 In VPN USER ID, enter ID and press the Hold button.
 In VPN USER PASSWORD, enter Password and press the Hold
button.
To set default Config. settings:
 In Network Config. Menu, use VOL   buttons to locate the
Default Config. Screen (shown),
SET DEFAULT CONFIG(DOT:*)

 Press the * key.
To exit Config. settings:
 Press the SPEAKER button,
 Press the * key to exit,
OR
 Press the # key to Reset/Reboot the phone with new setting.