Sketch 182
Shift key and use the arrow keys to resize the area. Press Enter to fix the
selected area to the sketch.
To move an area:
• Select an area then tap inside the selected area with the pen and drag the
area to the new position. You can also or move the area using the arrow
keys. Tap elsewhere press Enter to fix the selected area to the sketch.
You can turn selected areas over, and turn them round at angles of 90 degrees.
To flip part of a sketch:
• Select the area and then select either Flip horizontally or Flip vertically
on the Transform menu.
To rotate part of a sketch:
• Select the area and then select Rotate on the Transform menu.
Transparency
When you move a selected area you can ‘overlay’ it on top of an existing area
of the sketch. You can specify whether the existing sketch shows through by
making areas ‘transparent’.
To make a selected area transparent:
• Either press on the toolbar, or ensure that Make transparent on the
Transform menu is ticked.
To make the selected area opaque (so that any underlying sketch does not
show through):
• Either press on the toolbar or remove the tick on Make transparent
on the Transform menu.
Erasing & undoing
You can delete either all or part of your sketch, or undo up to the previous five
actions you performed.
To delete part of your sketch:
• Tap , or select the Erase drawing tool on the Tools menu. Use the pen
or the arrow keys to delete part of the picture, starting from the cursor
position.
To change the width of the Erase tool:
• Tap on a width in the toolbar, or select the Width palette tool on the Tools
menu. Change the width as required.
To delete the whole sketch:
• Select Delete all on the Edit menu.
To remove the last action performed:
• Tap , or select Undo on the Edit menu.
Changing colours
You can change the colour of an area by selecting a different colour and using
the Freehand drawing tool to draw over the existing colour. You can select
To Next Page
Loading...