ERS
®
Manual / AirCool
®
plus
-System / SP72_TA1C8 / -55°C +200°C / Ver. 02.02 28
7.2 Key functions
(1) ON/OFF Power switch
After switching on all LED's of the operation panel are turned on for a
short time.
Then the temperature is set to +25°C and the unit is ready to use.
(2) Key pad
0-9 - to enter set temperature values
- - sign for negative values
* - to cancel inputs in enter mode
(3) Enter
to enter a new set temperature value
action: reaction:
press enter enter key LED lights up
select T1 or T2 key LED T1 or T2 is flashing
use the key pad (2) to enter the entered value is shown at the
the new set temperature display (17)
To immediately activate the entered value as set temperature press the
respective key T1 or T2.
To store the value for later use press enter to terminate the input.
If no value is entered via the key pad, the stored set temperatures T1
and T2 can be monitored without changing the actual set temperature.
To leave the enter mode just press enter again.
(4) Function key T1
activates the stored value as new set temperature.
To change the value of T1 see (3).
(5) Function key T2
activates the stored value as new set temperature.
To change the value of T2 see (3).
(6) Preset +25°C key
Function key to activate the preset +25°C as set temperature.
(7) Step down key
The active set temperature T1 or T2 is decremented by one step (0.1°C),
the stored value is also changed by this operation. There is no influence
on the preset +25°C key.
To Next Page
Loading...