ES&S DS850 - Page 152

Chapter 10: System Messages 146
EVS5200_DOC_SOP_DS850
Software Version 2.10
Published: February 26, 2014
1009511 - Camera
Interface - Error
cropping
X X X This message appears when a ballot is
scanned, but the BAPis Image Processor
Board cannot properly crop the scanned
image(s).
Write down the error message and notify an
appropriate election official. If possible,
shutdown and then turn off the Scanner. Wait 30
seconds and then turn the Scanner back on. If
the problem persists, an ES&S Service Technician
will need to be contacted. Since the BAPis Board
is a “COTS” (Commercial Off The Shelf) product,
the ES&S Technician may have to contact a BAP
Technician to diagnose the problem.
1009512 - Camera
Interface - Buffer
overflow
X X X This message appears when a ballot is
scanned and its resulting image data
overflows the buffer of the BAPis Image
Processor Board.
Write down the error message and notify an
appropriate election official. If possible,
shutdown and then turn off the Scanner. Wait 30
seconds and then turn the Scanner back on. If
the problem persists, an ES&S Service Technician
will need to be contacted. Since the BAPis Board
is a “COTS” (Commercial Off The Shelf) product,
the ES&S Technician may have to contact a BAP
Technician to diagnose the problem.
System Messages
NOTE: A System Halt is a condition which requires the DS850 to be shutdown. It is not a condition which prevents the scanning of ballots.
Message Text
Message
Displayed
Message
Printed
Message
Logged
Results in a
System Halt
Cause Resolution