Chapter 5: Pre-Election Day Tasks 70
EVS5200_DOC_SOP_DS850
Software Version 2.10
Published: February 26, 2014
2. Load the election definition; see Loading the Election Definition.
3. Print the Zero Report to verify that ballot totals are all zeros.
4. Scan the test deck of ballots; see Scanning.
5. Print the Results Report.
6. Compare your reports to the ones provided by ES&S to verify that the scanner is
operating properly.
7. Clear the election results; see Clearing Election Results.
8. Print the Zero Report to verify that ballot totals are all zeros.
Note: If you turn off bin sorting for logic and accuracy testing, be sure to set the bin sorting
options as required for your election after the testing has been completed. See Bin Sorting
for information on turning off bin sorting.
Reference: See Chapter 8: Reports for more information on the Zero and Results reports.
To Next Page
Loading...