17
Fit the Horizontal Powerflue Wall Terminal into the hole and fix in place, making sure the installation is
sealed appropriately to prevent the ingress of water from outside the wall cladding.
NOTE: It is the responsibility of the installer to ensure the Horizontal Powerflue Wall Terminal is
installed to all relevant building codes to ensure weather tightness. This may necessitate the use of
appropriate flashing material where appropriate.
IMPORTANT: Ensure that flashings do not restrict the air intake slot around the periphery of the cowl
How to flash the Horizontal Powerflue
The following diagrams are excerpts from the escea architect drawings, and are available in full on our
website. These diagrams are recommendations, and your installation must comply with any local or
national building codes.
To Next Page
Loading...
