51
S3 Cleaning the Fuel bed and Glass
ALWAYS USE GLOVES WHEN HANDLING THE FASCIA AND GLASS.
NEVER RUB THE FASCIA.
The outside of the fascias must only be cleaned with a clean damp cloth, dry o after cleaning.
The high temp silver powder coating that is used on Escea fascia parts contains certain amounts of
aluminium that when rubbed too hard will oxidise leaving a black smudge that cannot be removed.
Always clean when cold.
This is a service procedure that will need to be carried out whenever soot builds up on fuelbeds and/or
inside of glass.
If soot build up becomes excessive or regular then one of the following actions may be required;
• Reset gas pressure, pressure may be too high;
• Reposition fuelbed, check with specific fuelbed instructions for details;
• Clear any blockage from primary aeration port of burner;
• Check flue tube is not damaged or disconnected.
• Check exhaust fan is operating and cowl is not blocked in any way.
S4 Cleaning the Fascia
NEVER RUB THE FASCIA. The outside of the fascia’s must only be cleaned with a clean damp cloth,
dry o after cleaning. The high temp silver powder coating that is used on Escea fascia parts contains
certain amounts of aluminium that when rubbed too hard will oxidise leaving a black smudge that
cannot be removed. For stainless steel fascias: we recommend the use of Steel Kleen brand Ezi Wipes.
Always clean when cold.
S5 Checking Operating Pressure
See section E7 of this manual.
To Next Page
Loading...
