Escea DS1400 - S6 Replacing a Remote Control; S7 Replacing the Burners; S8 Serial Number

B
A C D E F G SERVICE
52
S6 Replacing a Remote Control
If the wireless control becomes lost or damaged, a new one can be ordered from
any Escea retail agent. When you have the new remote, the following procedure
needs to be followed to “teach” the remote to only communicate with that fire.
1. Ensure the fire and remote are set to “O” (only the time is displayed on the
remote).
2. While the remote is in its “OFF” mode with only the time showing on the
display, press the MINUS, PLUS and FAN BOOST buttons simultaneously
(as shown right) until the characters “03” light up on the display. Release the
buttons and the remote will count down and display “GO”. The screen will then
display all characters and should be reading 00. This will put the remote into
test mode. Note: if the digits start counting then the remote is already paired.
3. Press and hold the – (minus) button until the two large temperature digits
reading 00 start to flash slowly. Release the – (minus) button. The remote
control is now ready to be addressed to the fire.
4. Press and hold the auxiliary on/o button on the fireplace for a minimum of ten seconds, or until
the two large temperature digits start counting upwards from 00 to 99 repeatedly.
Note: Pressing the red auxiliary button on/o button will start the fire. Once the remote control is
counting the fire can be turned o by pressing the red auxiliary button again.
5. Press the large power button in the middle of the remote control to exit the test mode and return
to normal operation. The remote should only be displaying the time. Check the fire will start using the
remote control by pressing the large power button. Turn it o again using the remote control.
6. The fire is now re-addressed to the remote control.
S7 Replacing the burners
Remove all of the fuelbed, taking care not to damage any or media.
Remove the 4 screws in the infill and lift from the fire box, by lifting one end up into the top corner
and then out towards you. Take care not to scratch the firebox paint and lift out the burners.
S8 Serial Number
The serial number for the fire can be found in two places. The first is in the battery compartment of
the wireless remote under the batteries. The second is on the data sticker on the chassis under the
electronics tray.
T
I
M
E
R
S
E
L
E
C
T
A
C
T
I
V
A
T
E
T
I
M
E
R
SET TIME