ETAS ES930.1 - Simple Cabling Concept of Inputs and Outputs; Additional Properties

ETAS Hardware Description
ES930.1 - User Guide 16
3.2.3 Simple cabling Concept of Inputs and Outputs
• Overall, only three different cable types are required for connecting the
inputs and outputs of the module.
• The open connections of these cables offered by ETAS can be individu-
ally fitted by the used, thereby adapting it to the specific plug connection
system of the measuring setup.
• The DSUB cable connections of the inputs and outputs of the module
allow the user a simple fitting of separate cables for flexible integration
in the measuring setup.
3.2.4 Additional Properties
• Automotive-ready module that is suitable for the use in the development
environment and in the vehicle on test tracks.
– Neutral to extreme environmental conditions (temperature, EMC)
– Expanded supply voltage range
– High mechanical stability and robustness
• Integration in the ETAS MC software INCA and in the rapid prototyping
software INTECRIO or ASCET-RP
• Standalone operation with ES93x configuration tool
• Updating the firmware of the module with HSP
The complete technical data of the ES930.1 can be found in chapter 13
on page 85.