ETAS ES930.1 - Page 77

ETAS Handling of Problems
ES930.1 - User Guide 77
The measurements do
not start.
Are you being asked to
update in the INCA moni
-
tor log or in the Config
tool?
Update the modules.
Does the module not fur-
nish any data?
Check whether your
power supply and your
measuring setup meets
the requirements
according to chapter
3.5
on page 21.
Check whether the
cabling of the hardware
to the PC is correct and
functional.
Check whether the mod
-
ules in the module chain
are correctly connected.
You are using the ETAS
daisy chain configura
-
tion tool and the module
does not furnish any
data?
Check whether you
changed the position of
one or several modules
in the chain.
Check whether you
loaded the measuring
configuration into the
module chain.
Check whether you
assigned the same IP
address to two module
chains.
Does the module not fur-
nish any usable data?
Check whether the sen-
sor or the sensor supply
is correctly connected.
Problem Diagnostics questions Possible solutions