118 Element User Manual
Move To
{Move To} is used to move cues from one location in a cue list to another location in the list. When
cues are moved, values that were tracks or move instructions and now match the previous cue will
be auto-blocked by the system. The impact on subsequent cues is based on track/cue only settings
as described above. Below is an example of {Move To}:
• [Cue] [2] {Move To} <Cue> [9] [Enter] - the contents of cue 2 moves to cue 9. Cue 2 is
deleted. If cue 9 already existed, a confirmation would be required to overwrite it. You can also
hit [Copy To] [Copy To] to access {Move To}.
In the above example, any tracked values in cue 2 become blocks (see Block, page 110) or moves
in cue 9, as well as any move instructions which now match the previous cue. Cues after cue 9 are
affected based on the default setting of track/cue only. Any values in the cue after cue 2 that tracked
from moves in cue 2 are changed to move instructions.
Ranges of cues can be moved as well. If any cue is to be overwritten, a confirmation is required.
To Next Page
Loading...
