D Facepanel Shortcuts 251
Appendix D
Facepanel Shortcuts
Overview
The following is a list of button pushes: single, maintained, or combined. It is highly recommended
that you read and familiarize yourself with this list. For keyboard shortcuts, see the Eos Family v2.0
Hot Keys Quick Guide.
Facepanel and Displays
• [Shift] & [Escape] - To lock and unlock face panel
• [Shift] & [Format] - Blind spreadsheet – expose/suppress non-intensity parameters
• [Live] – When already in Live Resyncs the selected cue to the most recently activated cue.
• [Blind] - When already in blind. Resyncs the selected cue to the live selected cue (when blind
cue has been changed or when preserve blind cue has been enabled).
• [Shift] & [Label] – Maintained press, toggles the display between default view of referenced
data and alternate view. Keep [Shift] depressed to page.
• [Browser] & [Level Wheel]- Dim the littlelites
• [Data] – Maintained press, Toggles the display to show data living under referenced data.
Keep [Data] depressed to page.
• [Format] & [Level Wheel] - Zooms the display in focus
• [Shift] & [Select] - Reset Display Columns
• [Shift] & [Up], [Shift] & [Down], [Shift] & [Level Wheel] - Resize columns
• [Shift] & [Left], [Shift] & [Right] - Move columns
Operations
• [At] [Enter] - Removes move information from selected channel/parameters. If done in live,
posts the value from the previous cue (numeric) manually. If done in blind, allows the value
from the previous cue to track in.
• [Sneak] [Sneak] - Releases NPs of selected channels and self terminates
• [At] [At] - Set to Level
• [Full] [Full] - Sets selected channels intensity to “full” and self terminates
• [Thru] [Thru]- The thru command accesses only the channels displayed in the current flexi-
state (unless the channel range specified is NOT in the current display). [Thru] [Thru] selects
the range regardless of the flexi mode.
• [Undo] - Clears an unterminated command line. Otherwise opens undo controls
• [Shift] & [Clear] - Clears the command line.
• [Copy To] [Copy to] - Posts Move To on the command line.
To Next Page
Loading...
