252 Element User Manual
• [Shift] & [Sneak] - Makes manual data “unmanual”. It leaves the values as they are, but they
are then no longer available for update or record only operations. When executed from an
empty command line, this affects all manual data. When done with a channel selection, this
affects only those channels.
• [Shift] & [Full] - Flash On
• [Shift] & [Out] - Flash Out
• [Shift] & [+] - +%
• [Shift] & [-] - -%
• [Shift] & [Update] - Shortcut to “Save”
• [Recall From] [Recall From] - Posts Recall From Cue to the command line
• [Shift] & [At] - Recalls last channel(s) and parameters
• [Shift] & [Last] - Repeat last command line, without values
• [Update] & [Sub Bump] - To update a specific submaster
• [Label] [Label] - Appended to a record target command, clears the current label, this includes
show file labels.
• [Shift] & restore manual channel faders - Reset faders to zero without asserting control.
• [Shift] & [Delay] - Posts follow
• [Trace] [Trace] - Forces a previously inactive light to track its new intensity setting backwards.
• [Record] [Record] - Posts Record Only to the command line
• [Shift] & [Block] - Posts Intensity Block to the command line
To Next Page
Loading...
