F Remote Control 263
Park Mode
This mode is used for parking channels.
Softkeys
The following softkeys are available in park mode:
•Address
• Channel
•Last
•Full
•Out
•Next
{Address} and {Channel} are used to select addresses or channels for parking.
• <Channel> [7] [@] [5] [Enter] - parks channel 7 at 50%.
• {Address} [8] {Full} - parks address 8 at full.
{Full} and {Out} are used to set those levels for channels or addresses. {Out} parks the channel or
address at 0.
• [9] [@] [Enter] - unparks channel 8.
In this mode, the thumbwheels will also function as next and last commands.
To Next Page
Loading...
