E8_Aus_rev07 – 2021-02-02
Euronda E8 is equipped with a system for controlling all the components of the unit; when the
Process Controller detects a fault either in a component or in the overall behaviour of the
machine, an error message appears, preceded by an intermediate “Please wait” screen, necessary
for the machine to perform its pressure levelling.
END OF CYCLE AND ERROR SCREEN
This screen appears after a manual stop before
the end of the sterilisation cycle, or when an
operation error has caused the unit to stop the
cycle, and therefore the load is not sterile. The
screen shows the name of the cycle at the top
and the relative error code at the bottom (in this
case) and the door locked icon (padlock). If this
screen error appears due to a manual stop by
the user, the error code is not used (like in this
case).
The door is locked. Touch the middle button to
release it.
LOAD WET END-OF-CYCLE SCREEN
This screen appears when a cycle is interrupted
by a manual stop ordered by the user, after the
end of the sterilisation phase: the load in the
boiler is sterile, but the drying process has not
been completed. The load can therefore only be
used immediately and cannot be preserved.
The door is locked. To release it, touch the
central part of the screen.
To Next Page
Loading...
