Euronda Pro System E8 - Page 73

E8_Aus_rev07 – 2021-02-02
72
W88
The conductivity read by the
conductivity meter on the
autoclave is at the limits of
the acceptable values.
Empty the clean water tank, and refill it with
demineralised or distilled water of the best
quality.
Bacteriological filter to be
replaced
M1
This is not a forcing notice. When it appears,
exit pressing the low central icon.
Replace the filter with turned off autoclave as
soon as possible, or contact the technical
assistance.
Door silicon gasket to be
replaced
M2
This is not a forcing notice. When it appears,
exit pressing the low central icon.
Contact the technical assistance in order to do
the maintenance.
Extraordinary maintenance
M3
This is not a forcing notice. When it appears,
exit pressing the low central icon.
Contact the technical assistance in order to do
the maintenance.
W73
Tank cleaning
M4
This is not a forcing notice. When it appears,
exit pressing the low central icon. Tank
cleaning is suggested in order to avoid
sediments.
Do the cleaning with turned off autoclave.
W81
Upper band heater
temperature not suitable for
cycle start.
Resistance fault.
W82
Upper band heater
temperature not suitable for
NGV cycle start.
Resistance fault.
W90
Steam generator temperature
sensor faulty.
Switch the steriliser off and then back on
again. If the problem persists contact the
assistance service.
W91
Upper band temperature
sensor faulty.
Switch the steriliser off and then back on
again. If the problem persists contact the
assistance service.
W92
Lower band temperature
sensor faulty.
Switch the steriliser off and then back on
again. If the problem persists contact the
assistance service.
W93
Faulty condensation battery
sensor.
Switch the steriliser off and then back on
again. If the problem persists contact the
assistance service.
W94
Pressure sensor faulty.
Switch the steriliser off and then back on
again. If the problem persists contact the
assistance service.