42
Eversense E3 CGM User Guide
5
Caution: If you have any concerns about allergic reaction to silicones, contact your healthcare provider prior
to use. Discard the patch after 24 hours of use.
Secure the Smart Transmitter over Inserted Sensor
The smart transmitter must be secured on the skin directly over the sensor with the disposable adhesive patch. Each
adhesive patch is designed to be replaced daily and has an adhesive side that attaches to the back of the smart
transmitter and a silicone adhesive side that attaches to the skin. Both the skin and smart transmitter surfaces should
be clean and dry to secure the adhesive surfaces of the patch. During the first few days after insertion, you will
wear the smart transmitter over the Tegaderm bandage. Leave the Tegaderm bandage in place for as long as your
healthcare provider instructs. Discard used adhesive patches in accordance with your local regulations.
Note: You will receive adhesive patches from your healthcare provider. Adhesive patches are provided in both
white and clear material. The white adhesives are perforated, allowing for moisture to be wicked away. The clear
adhesives allow for use on the occasions you may want more discretion.
1. Peel o the paper backing with the Eversense E3
Smart Transmitter outline on it. Try not to touch the
sticky portion of the adhesive in the centre.
2. Align the smart transmitter over the sticky side
(centre) of patch and press firmly to secure.
• The smart transmitter should be placed so that its
sides face the wings of the patch (as shown).
5
To Next Page
Loading...
