IPLEX TXII
TIP:
Part of the field of view may be lost when the protective sleeve is attached.
If part of the field of view is missing, try the following two adjustments.
l
Rotate everything except the retaining ring.
Observe at a position that does not block the field of view.
l
Remove the protective ring [a] by rotating it counterclockwise. Remove the washer
[b] , and then rotate the protection ring [a] clockwise to attach it.
Up to three washers [b] can be removed, but be careful not to let the tip of the scope
protrude from the sleeve. Using the scope tip protruding from the sleeve may damage
the scope.
How to remove the protection sleeve
Remove the protective sleeve by doing the installation procedure in reverse.
21
To Next Page
Loading...