Evident IPLEX TXII - 3 Preparation and Inspection before Operation; Preparing the Product; Removing the Control Unit from the Carrying Case; Attaching the Scope Unit to the Control Unit

Be sure to perform the preparations and inspections described in this chapter before use. If
you encounter any abnormality, please stop using it immediately and follow the procedures
in "Troubleshooting " (page 43).
Also, perform inspections not only before use, but also on a periodic basis.
NOTE:
Be sure to turn off the power before performing preparations and inspections before
operation.
3.1 Preparing the product
3.1.1 Removing the control unit from the carrying case
1.
Remove the control unit and spacer cushion from the carrying case.
NOTE:
The spacer cushion is necessary for repackaging the product. Store it in empty space in the
carrying case.
3.1.2 Attaching the scope unit to the control unit
1.
Remove the scope unit from the packing box.
2.
Remove the protective caps from the control unit and scope unit.
3. Preparation and inspection before operation
16