IPLEX TXII
6.1 Cleaning each part
6.1.1 Cleaning the inserting part
If foreign bodies such as dust adhere to the inserting part, or if it becomes dirty
Wipe it with a clean, soft cloth.
If liquid such as dirty water or machine oil adhere to the inserting part
Do not use a hard cloth or brush, rather wipe with a soft cloth or cotton swab, and thoroughly
wash with gauze moistened with a cleaning liquid such as a neutral detergent. After that,
wash with a soft gauze moistened with clean water, wipe off the moisture well, and dry the
product.
NOTE:
Clean the inserting part immediately after pulling it out. Over time, dirt may adhere to the
inserting part or cause it to corrode.
6.1.2 Cleaning the tip
If the objective lens at the tip is dirty or has water droplets
Hold the hard part of the tip and use a clean, soft gauze or cotton swab to wipe off dirt and
water droplets.
Alternatively, use a brush to carefully scrape it out.
If you use commercially available absolute ethanol or isopropyl alcohol for this you can wipe
dirt/droplets off more cleanly.
Swab Brush
6.1.3 Cleaning other units
If a unit other than the inserting part and tip becomes soiled, wipe it with a soft cloth
moistened with clean water. After that, lightly wipe it with a dry, clean cloth to finish.
6. Maintenance
45
To Next Page
Loading...