Exhaust Grommet 115 – 300 HP Models
A new exhaust grommet is used on all V4 and V6 models.
The new exhaust grommet features ribs to strengthen the grommet and reduce
flexing around the insert area. This improves retention of the overboard indicator
hose.
When installing an exhaust grommet, clean and dry all parts. Make sure the Oet-
iker clamp that retains the overboard indicator hose is correctly positioned. Refer
to the appropriate Service Manual for installation instructions.
Exhaust grommet, P/N 5008518 services all 2005 and newer 115 – 300 HP
Evinrude E-TEC models.
Fuel Hoses – All Models
New and revised U.S. Environmental Protection Agency (U.S. EPA) regulations
have resulted in a number of changes to fuel hoses.
New fuel rails are used on all 40 – 300 HP models. The new fuel rails are con-
structed with a three layers of material to meet the U.S. EPA requirements for
evaporative emissions.
Service parts for older product will supersede to new part numbers. Refer to the
appropriate Parts Catalog for correct parts ordering information.
To Next Page