55
I-COMMAND
DealerPort
I-Command Water Pressure Sensor Kit, P/N 5008300
Use this kit to provide water pressure data to I-Command or other instruments
on a NMEA 2000 network. Install this kit on Evinrude E-TEC 115 – 300 HP out-
boards only.
The water pressure sensor used in this kit is capable of providing water pressure
readings from 0 to 30 psi (0 to 206 kPA).
Refer to the installation instructions provided with the kit for correct installation.
The water pressure sensor MUST be installed in a vertical position. Hose instal-
lation MUST provide complete drainage of water from the sensor.
Software for I-Command Devices
Software is available to update I-Command digital gauge and device software.
Log into DealerPort (www.dealerport.com) or BOSSWeb (www.boss-
web.brp.com) to download the latest I-Command software and information.
Refer to I-Command Software Update Kit, P/N 765357 on p. 63.
To Next Page