Evinrude E-tec 2011 Series - Page 87

85
APPENDIX
The table provides a reference to information presented in previous Product Service Updates.
Model Topic
Where to Find (Book Year /Section)
Other References
15 – 30 Flywheel servicing
2010 - Service Tips
15 – 30 Water pump servicing
2010 - Service Tips
25 – 30 New model rigging information 2009 - Rigging
Predelivery Bulletin
2008-02(D)
25 – 30 New model warning system information 2009 - Rigging
25 – 30 Step required to install battery charge module 2009 - Diagnostic Software
25 – 30 EMM Light Emitting Diodes (LEDs) 2009 - Engine Management Module
25 – 30 Code 120; Oil level switch open circuit detected 2009 - Service Codes
25 – 30 Fuel injector seal kits 2009 - Fuel System
25 – 30
Fuel injector and vapor separator servicing, new
procedure
2009 - Fuel System
Service Bulletin
2008-07(S)
25 – 30 Oil recirculation diagram (new model) 2009 - Oiling Systems
25 – 30 New accessory kits for Evinrude E-TEC 25/30 HP 2009 - Parts & Accessories
40 Tilt assist kit for manual tilt models 2008 - Parts & Accessories
40 Rope start models - revised oil pump wire harness routing 2009 - Ignition & Electrical
40 – 60 Water pump o-ring eliminated 2008 - Cooling System
40 – 60 Vented water pump housing 2008 - Cooling System
40 – 60 Melted propeller hardware or Hydrus exhaust ring 2008 - Cooling System
40 – 60 Cover design change 2008 - Engine Covers
40 – 60 Oil recirculation changes 2004/2005 to 2006 & newer 2008 - Oiling System
40 – 60
New trim and tilt assembly, P/N 5007774 - manual relief
valve improved
2009 - Midsection
40 – 90 Engine idle temperature 2008 - Cooling System
Service Bulletin
2006-07(S)
40 – 90 Engine cover material 2008 - Engine Covers
40 – 90 Spark plug replacement - inductive ignition models 2008 - Ignition & Electrical
40 – 90 Spark plug life 2008 - Ignition & Electrical
Service Bulletin
2006-07(S)