4 Description of the System components
4/7
4.4 Volt - Ammeter Displays
4.4.1 M110: digital V/A- Meter with Hold- Function (Option for M100 / M201)
Fig.: 4/6; Operating panel digital voltage and current display M110
1
Digital Welding Current Display
2
Digital Welding Voltage Display
4.5 The Remote Control (Option, only for use with the M201)
Only remote controls which are described in this manual may be connected!
Remote controls may only be plugged in or unplugged when the unit is switched off!
The welding machine automatically recognises the remote control when switched on.
The machine have to be supplied with the option „connection possibility remote control and
Torch remote control“.
4.5.1 Hand Remote Control (Option)
•
Connect remote control to remote control socket (see 4.2).
Rotary knob for the stepless setting of:
•
Correction of the wire-feed speed
•
Wire-feed speed 1 - 20 m/min
(Selector switch
6
Kap. 4.3.1 set to Manual
position)
Connection plug 19 polig with 5m connectioncable
To Next Page
Loading...
