6 Description of M201 control
6/5
6.5 Correcting the wire feed speed
6.5.1 Correcting the wire feed speed with the remote control (Option)
Setting the correction of the wire feed speed (one knob operation) or the wire feed speed
(Operating mode manual, two knob operation) can be carried out independently of the settings on
the control.
6.5.2 Correcting the wire feed speed with the remote control on the welding torch
(Option)
•
Connect the welding torch with potentiometer to the central connection on the welding machine.
•
Plug the torch control cable into the remote control socket.
Setting the correction of the wire feed speed (one knob operation) or the wire feed speed
(Operating mode manual, two knob operation) can be carried out independently of the settings on
the control.
6.6 M110 (Option) digital V / A - Meter with Hold - Function
6.6.1 Display of actual welding data during and after welding
The digital V/A meter M110 is available as an option for the M100 and M201 controls.
With this display the Welder is kept informed of the actual current values for voltage and current
during welding. What is more, the last values for welding voltage and current measured are stored
in the display (Hold- Function).
To Next Page
Loading...
