EWM SATURN MIG 300 PROGRAM - Default Chapter; Table of Contents

CONTENTS Page
Contents/1
Safety Instructions ................................................................................................................Safety/1
Instructions for the use of this Operating Manual ...................................................Instructions/1
1 About this step switched machine....................................................................................... 1/1
1.1 The advantages of these MIG/MAG- Welding Machines ................................................. 1/1
1.2 Controls............................................................................................................................ 1/2
1.2.1 Control M100....................................................................................................... 1/2
1.2.2 Control Program M201 ........................................................................................ 1/3
1.3 Range of Applications....................................................................................................... 1/4
2 Transport and Installation.....................................................................................................2/1
3 Technical Data........................................................................................................................ 3/1
3.1 SATURN - Series ............................................................................................................ 3/1
4 Description of the System components.............................................................................. 4/1
4.1 System Summary............................................................................................................. 4/1
4.2 The Welding Power Source.............................................................................................. 4/2
4.2.1 SATURN 200 - 300 Welding Machine Series (Front- and rearview) ................... 4/2
4.3 Controls............................................................................................................................ 4/4
4.3.1 Control “PROGRAM“ M201................................................................................. 4/4
4.3.2 Control M100....................................................................................................... 4/6
4.4 Volt-/ Ammeter Display..................................................................................................... 4/7
4.4.1 M110: digital V / A - Meter with Hold - Function
(Option for M100+M201) ..................................................................................... 4/7
4.5 The Remote Control (Option only with the M201)............................................................ 4/7
4.5.1 Hand Remote Control RM (Option only with the M201)
...................................... 4/7
4.5.2 Remote Control On the welding torch (Option only with the M201) .................... 4/8
4.6 The Interfaces(Option, only with the M201) ..................................................................... 4/8
4.6.1 Automation Interface (Option) ............................................................................. 4/8