EWM SATURN MIG 300 PROGRAM

To Next Page

EWM HIGHTEC WELDING GmbH

Dr.-Günter - Henle - Straße 8; D-56271 Mündersbach

Phone: +49 (0)2680.181-0; Fax: +49 (0)2680.181-244

Internet:

www.ewm.de ; E-mail: info@ewm.de

Operating Manual

SATURN MIG 200 - 300

SATURN MIG 200 - 300 PROGRAM

for Standard MIG/MAG Welding.

SATURN MIG 200, MIG 200 PROGRAM

SATURN MIG 250, MIG 250 PROGRAM

SATURN MIG 300, MIG 300 PROGRAM

The operating manual must be read before using the machine!

It can be dangerous to ignore this!

The machine may only be used by personnel who are familiar with appropriate regulations!

This machine bears the CE-mark and thus confroms with the

· EU-low voltage guidelines (73/23/EWG)

· EU-EMV- guidelines (89/336/EWG)

(The CE-mark is only required in countries which are members of the European Union).

Units may be used in accordance with VDE 0544 (EN 60974-1) in areas where increased

electrical danger exists.

ãã

ã 2000 Subject to technical change! Art. Nr.: 099-004305-EWM01 Stand: 28.08.2000

Main Page

Need help?

Do you have a question about the EWM SATURN MIG 300 PROGRAM and is the answer not in the manual?

Summary

Safety Instructions

General Safety Precautions

Covers essential safety guidelines for operating welding equipment, including personal protection and general warnings.

Specific Hazard Warnings

Details risks related to electric shock, smoke/gases, hot components, fire, noise, and electromagnetic interference.

Controls and Operation

M100 Control and M110 Display

M201 Control System

Details the M201 microprocessor control, its programs, functions, and applications.

Installation and Data

Technical Data

Presents detailed specifications for the Saturn welding machine series, including current, voltage, and power.

Control Panel Operations

M201 Control Functions

Explains M201 control settings for welding tasks, operating modes, and parameter adjustments.

M100 Control Functions

Advanced Control Features

M100 Control Details

Explains M100 control principles, operating modes, and choke tapping selection.

Setting Welding Parameters (M100;M201)

M201 Specific Operations

MIG;MAG Welding Job Setup

Commissioning Procedures

Machine Setup and Connections