EWM SATURN MIG 300 PROGRAM - M201 Specific Operations; MIG;MAG Welding Job Setup

6 Description of M201 control
6/1
6.1 Description of MIG/MAG Welding jobs
Al
manuell
1-20 m/min1-20
m/min
0.6
1.2
1.0
0.8
0.6
0.8
1.0
1.2
CrNi
SG
SG
100% CO2
SG
100% CO2
SG/CrNi
90-100% Ar
SG/CrNi
90-100%
Ar
AlMg
100% Ar
AlMg
100% Ar
AlSi
100% Ar
AlSi
100%
Ar
Al99
100% Ar
Al99
100% Ar
SG/CrNi
80-90% Ar
SG/CrNi
80-90% Ar
PROGRAM
0.1
2
1
3
4sec
m/min
0
2
4
6
8
-10
2
4
6
8
+10
15
201
5
10
GEN-A3GENTITLEGENTITLE0201GEN-POSGEN-SUMCANONIICANONII1.01.0EDITMISO1:11
M201
Fig. 6/1: M201 Control
The microprocessor controlled MIG/MAG control “PROGRAM“ M201 works on the one knob
operating principle i.e. :
To define his working point the user must only pre-set
• the type of gas,
• the type of material and the welding wire diameter as well as
the welding power, using the step switch.
This defines the welding task and when the torch trigger is pressed the control system gives the
wire feed speed for the optimum working point.
The user has the possibility of correcting the wire feed speed according to the welding task or to
individual requirements.
Correction of the wire feed speed may be done:
• on the PROGRAM M201 control,
• on the remote control (Option)
• or on the welding torch with rotary knob (Option).