Test Setup - Test Configurator, Timer, and System
204 FTB-700G/800 Series
Remote Details (iSAM)
For Remote Loopback Operation Mode
Loop-Up button establishes the connection with the selected remote
module and sets the remote module into Smart Loopback test
application.
Following a successful loop-up, the IP address of the remote module
will be used as the destination IP address for the test.
Overtake button manually establishes the connection with the remote
module and set the remote module into Smart Loopback test
application. Available when the status is Taken or Test in Progress
with another unit. A confirmation is required to overtake a module.
Loop-Down button ends the connection between the local and the
remote modules.
For DTS Operation Mode
Connect button manually establishes the connection with the selected
remote module and sets the remote module into DTS EtherSAM test
application.
Following a successful connection, the IP address of the remote
module will be used as the destination IP address for the test.
Overtake button manually establishes the connection with the remote
module and set the remote module into DTS EtherSAM test application.
Available when the status is Taken or Test in Progress with another
unit. A confirmation is required to overtake a module.
Following a successful connection, the IP address of the remote
module will be used as the destination IP address for the test.
Disconnect button, available once the connection with the remote
module is established, terminates the connection with the remote
module. Available when the status is Ready.
To Next Page
Loading...
