Extron electronics SSP 200 - Page 84

SSP 200 • SIS Configuration and Control 76
Command SIS Command
(Host to Device)
Response
(Device to Host)
Additional Description
Outputs
Set HDMI Loop Thru
EX5#LOUT} LoutX5#]
View HDMI Loop Thru
ELOUT}
Verbose modes 2/3
X5#]
LoutX5#]
View Output HDCP
Status
EOHDCP}
Verbose modes 2/3
X5$]
HdcpOX5$]
Set Output HDCP Mode
ESX5%HDCP} HdcpSX5%]
View Output HDCP
Mode
ESHDCP}
Verbose modes 2/3
X5%]
HdcpSX5%]
KEY:
X5#
=
HDMI Loop Out mode: 0 = No audio 1 = Follow input 2 = Downmix (Default)
X5$
=
Output HDCP status: 0 = No sink detected 1 = Sink detected with HDCP 2 = Sink detected without HDCP
X5%
= Output HDCP mode: 1 = Auto: encrypt as required by input. Continuous trials for HDMI sinks. (Default)
2 = Always Encrypt Output: Continuous trials for HDMI sinks
Level Control
Output Channel Trim Settings
Set specific output
channel trim
EVX5&*X5*SSP} SspVX5&*X5*]
View specific output
channel trim
EVX5&SSP}
Verbose modes 2/3
X5*]
SspVX5&*X5*]
KEY:
X5&
= Analog output channel (channels 7–10 change depending on layout and downmix settings):
1 to 10 or 15 to 16
(see Output Channels Table on page68 for details).
X5*
=
dB value: –24 to 0 (default 0)
Audio Mute
Mute all output channels
(global mute)
1Z
AmtX6)]
Sets mute to on for all
channels.
Unmute all output
channels (global unmute)
0Z
AmtX6)]
Sets mute to off for all
channels.
View global mute status
Z
X6)]
Returns 1 when all outputs
are muted. Returns 0 if any
outputs are unmuted.
Mute specific channel
X5&*1Z AmtX5&*X6)]
Sets mute to on for selected
channel.
Unmute specific channel
X5&*0Z AmtX5&*X6)]
Sets mute to off for selected
channel.
View mute of specific
channel
X5&*Z X6)]
Shows the mute status of
the selected channel.
KEY:
X5&
= Analog output channel (channels 7–10 change depending on layout and downmix settings):
1 to 12 or 15 to 16
(see Output Channels Table on page68 for details).
X6)
=
Audio Mute: 0 = Mute off (default) 1 = Mute on