TLP Pro x25 Series and TLS x25 Series • Panel Features 10
C
Communication LED — (see figure 3 on page 9). Shows the configuration and connection status of the
touchpanel:
• Unlit during normal operation (the touchpanel is configured and connected to an IP Link Pro control
processor).
• Blinks if the touchpanel has been configured but is not connected to an IP Link Pro control processor.
• Lights steadily if the touchpanel has not been configured.
The indicator can be enabled and disabled, using the On-screen Menus on page 16).
D
Light sensor — Monitors ambient light level and adjusts screen brightness, based on the settings configured
using the Setup Menu.
E
Front status light — The TLS Series and TLP Pro 525M, 725M, and 1025M have two LEDs (one on each
side). The TLP Pro 525T, 725T, and 1025T have a single LED (in the center of the bottom edge).
• For the TLS series touchpanels, the lights remain lit steadily to indicate whether the room is occupied
(red) or available (green).
• For the TLP Pro touchpanels, the lights can blink or remain lit steadily and they can light red or green. The
lights can be configured (using Global Configurator) or programmed (using ControlScript programming) to
provide feedback information about the system using these variables. Different combinations, for example
a red LED lit steadily or a green LED that is blinking, can provide indications about the system.
For information about setting up these LEDs, see the Global Configurator Help File or the ControlScript
Deployment Utility Help File.
Communication LED
Light sensor
Front status light
To Next Page
Loading...
