TLP Pro x25 Series and TLS x25 Series • Reference Material 38
Reset Modes
The touchpanels described in this guide have three reset modes that are initiated by pressing the RESET button.
An additional (fourth) mode toggles between enabling and disabling the DHCP client:
• Use Factory Firmware (see below).
• Reset Network Settings (see page 39).
• Full Factory Reset (see page 39).
• Toggle DHCP Client (see page 40)
The RESET button is found on the rear panel of the TLP Pro 525M, 725M, and 1025M series (see figure 4,
B
, on
page 11) or the base of the TLP Pro 525T, 725T, or 1025T series (see figure 5,
B
, on page 13).
Use Factory Firmware
This mode is used to boot up the unit with factory-installed firmware for a single power cycle if a firmware update
fails or incompatibility issues arise with user-loaded firmware.
Activation
To start the Use Factory Firmware reset mode and replace firmware:
1. Remove power from the touchpanel.
2. On the touchpanel, hold down the recessed RESET button (see figure 4,
B
or figure 5,
B
) while re-applying
power to the unit. When power is restored, the Reset LED lights. Hold the RESET button for a further 2
seconds before releasing it. The touchpanel enters factory firmware mode.
3. Upload new firmware to the unit as desired (see Updating the Firmware on page 30).
NOTE: Do not continue to operate the touchpanel using the factory firmware version. If you want to use
the factory default firmware, you must upload that version again (see Updating the Firmware).
Result
The unit reverts to factory-installed firmware. Event scripting does not start if the unit is powered on in this mode.
All user files and settings such as drivers, adjustments, and IP settings are maintained.
NOTE: To return the unit to the firmware version that was running prior to the reset, cycle power to the unit.
To Next Page
Loading...