TLP Pro x25 Series and TLS x25 Series • Reference Material 39
Reset Network Settings
This mode resets all IP settings to factory defaults.
Activation
To reset all IP settings:
1. Hold down the RESET button for about 6 seconds until the Reset LED blinks twice (once at 3 seconds and
again at 6 seconds).
2. Release and press RESET momentarily (for <1 second) within 1 second. Nothing happens if the momentary
press does not occur within 1 second.
Result
Reset All IP Settings mode:
• Sets the IP address back to factory default (192.168.254.251).
• Sets the subnet back to factory default (255.255.255.0).
• Sets the default gateway address to the factory default (0.0.0.0).
• Sets all other IP settings, addresses, and domain and host names back to factory default.
• Turns DHCP off.
Full Factory Reset
This mode resets all IP settings and touchpanel settings, including passwords, to factory defaults and removes all
configurations. It allows you to start over with configuration and uploading.
NOTES:
• The factory configured passwords for all accounts on this device have been set to the device serial
number. Passwords can be changed during configuration. Passwords are case sensitive.
• If the device is reset using Full Factory Reset, the password is the default password configuration. The
default password is extron (for either admin or user accounts).
Activation
To reset the unit to all factory default settings:
1. Hold down the RESET button for about 9 seconds until the Reset LED blinks three times (once at 3 seconds,
again at 6 seconds, and again at 9 seconds).
2. Release and press RESET momentarily (for <1 second) within 1 second. Nothing happens if the momentary
press does not occur within 1 second.
Result
Reset to Factory Defaults mode performs a complete reset to factory defaults (except the firmware):
• Does everything “Reset Network Settings” mode does.
• Removes touchpanel user interface layout and configurations.
• Resets all touchpanel settings to factory default.
To Next Page
Loading...