Extron electronics XTP II CrossPoint Series User Manual

HTML Operation
The XTP II CrossPoint Matrix Switcher can be remotely controlled via:
• The XTP System Configuration software (see the XTP System Configuration Software
help file, available at www.extron.com).
• SIS commands (see Programming Guide, beginning on page 76)
• Built-in HMTL pages (see below)
This section introduces using the built-in HTML pages to operate the XTP II CrossPoint
Matrix Switchers, including:
• Download the Startup Page
• Status Tab
• Configuration Tab
• File Management Tab
• Control Tab
The switcher can be controlled and operated through its LAN port, connected via a LAN
or WAN, using a Web browser such as the Microsoft Internet Explorer. The display in the
browser of the status or operation of the switcher has the appearance of Web pages. This
chapter describes the factory-installed HTML pages, which are always available and cannot
be erased or overwritten.
NOTE: If your Ethernet connection to the matrix switcher is unstable, try turning off
the proxy server in your Web browser. In Microsoft Internet Explorer, click Tools >
Internet Options > Connections > LAN Settings, uncheck the Use a proxy
server
... box, and then click OK.
XTP II CrossPoint 1600, 3200, and 6400 Switchers • HTML Operation 119

Extron electronics XTP II CrossPoint Series Specifications

General

Brand	Extron electronics
Model	XTP II CrossPoint Series
Category	Matrix Switcher
Language	English