A951 19 532081 - RevA
7
8
2
3
3
9
1
10
1
5
Translation of the original instructions
ENGLISH
4. Remove the template and drill the holes at the
points that were marked.
!
Make sure that there are no pipes or electrical conduits
in correspondence with the holes to be drilled.
It must be mounted using screws (wall plugs, self-tap-
ping screws etc.) and adequately tightened in order
to the support the system.
5. Fasten the plate to the architrave using the previ-
ously drilled holes (7).
The plate should be positioned with its flat side
against the architrave.
Fasten the plate horizontally and check that it is
horizontal using a spirit level (8).
6. Install the cables as show in 9:
- Remove the mains power terminal board cover
(1) and place it temporarily to one side; then pass
the power cable (2) through the central housing.
- Be careful not to pinch the wires (3) by pulling them
out completely before fixing the operator.
7. Install the door operator on the plate and fasten it
using the 5 screws provided (10).
One screw is located under the transparent cover,
which should be removed and put temporarily to
one side.
To Next Page
Loading...
