FAAC A951 - Electronic Installation Guide; Communication and Mains Power Connection; I;O Board Connection

A951 25 532081 - RevA
3
22
23
1
2
1
3
Translation of the original instructions
ENGLISH
Brown
Blue
Yellow/Green
A951
6. ELECTRONIC INSTALLATION
RISKS
PERSONAL PROTECTIVE EQUIPMENT
F
ALWAYS DISCONNECT THE POWER SUPPLY before
working on the board. Turn power on only after
having made all the electrical connections and carried
out the preliminary start-up checks.
6.1 COMMUNICATION BOARD
Install the Communication board (§ 11), if used.
6.2 COVER
Replace the transparent cover.
6.3 CONNECTING TO THE MAINS POWER
SUPPLY
F
CARRY OUT THE FOLLOWING OPERATIONS WITH THE
ELECTRICITY SUPPLY DISCONNECTED.
With reference to 22:
- Connect the mains power cable to the terminals (1)
following the colour scheme indicated.
- Secure the power cable using the cable grip (2).
- Install the mains power terminal board cover (3)
and fasten it in place using the screw.
6.4 CONNECTING TO THE I/O BOARD
F
CARRY OUT THE FOLLOWING OPERATIONS WITH THE
ELECTRICITY SUPPLY DISCONNECTED.
1. Place the accessories connection cables in the
upper and lower guides and press the cable clips
(23).
2. Connect the wires to the terminal boards in 24.

The terminals are of the spring type: to insert or
remove the wires, press the button with the tip of
a screwdriver.