FAAC A951 - Battery Kit Installation Guide

A951 57 532081 - RevA
44
45
46
47
48
2
3
1
1
2
3
4
Translation of the original instructions
ENGLISH
13. BATTERY KIT
F
CARRY OUT THE FOLLOWING OPERATIONS WITH THE
ELECTRICITY SUPPLY DISCONNECTED.

The battery kit can only be mounted on the side
opposite the side functions selector.
1. With reference to 44:
- Remove the side cover (1) and the flange (2).
- Using a screwdriver or a gripper, remove the pre-
cut section (3).
2. With reference to 45:
- Replace the flange (1).
- Remove the battery pack from the enclosure (2).
- Press the enclosure onto the flange.
- Fasten it to the support using the two screws (3)
and the holes in the base of the enclosure.
- Press the side cover on (4).
3. Put the battery pack back into the enclosure
(46).
4. Connect the battery kit to the
Power board using
the cable provided, passing it through the opening
that was made after having removed the pre-cut
section in step1 (47).
5. Replace the transparent cover and press the casing
on (48).